top of page
High Gloss Liquid Epoxy Resin Kit
High Gloss Liquid Epoxy Resin Kit
How to apply
The tiles/ stones should be firmly set and the adhesive or bed mortar should be completely dry.
​
Remove the spacers before grouting. Grout joints must be clean and free of water, dirt or dust
Excess of mortar bed should be removed from tile joints. fil the tile joint with suitable latex modified tile grout, leaving a depth of min 2mm for filling with glass bond epoxy
All joints should be cleaned by washning with water/ detergent. Avoid any acid washing methods.
Ensure the joints are completely dry before grouting
.
1.Surface preparation
(PLEASE ENSURE PROPER PERSONAL PROTECTIVE EQUIPMENT"S (PPE) BEFORE MIXING)
Take 2 parts resin &1 part hardener in ratio 2:1 by weight
Mix the resin &hardener for a minute. Add required quantity of pigment/glitter to get the desired colour/texture and mix all the components for another 2 minutes.
Prolonged mixing is to be avoided as it traps air and shortens pot life
the mixed workable grout can be used up to 30 minutes at 30C
No water to be added in the mix
2. MIXING
3.PRODUCT APPLICATION
BEFORE THE APPLICATION ENSURE PROPER PPE
Only grout a small area at a time and ensure that the joints are firmly filled and free of voids
The application is done using the long nozzle applicator given along with the material.
wipe off any excess material immediately with a sponge or an appropriate tool.
the area should be cordoned to prevent any accidental damage to grout
After the grout has fully hardened 9Usually after 24 hours),Use a suitable sharp tool to remove any residue of grout left over on top of tiles.
Never use water for cleaning off the excess material.
bottom of page